Also pay attention to the notch cut in the bottom of the heat liner that goes around the factory washer nozzle.ġ5) Once the heat liner is slid back in, re-prop the hood.ġ5) Re-install the 5 plastic heat liner clips. One of these slots is where the factory washer line sets, so keep that in mind if it's difficult to get into place. There are six metal "slots" that the liner slides into. You'll need to lower the hood prop to get it situated back in place. After you get the pattern you want, snug the nozzle screws tightly without damaging your hood.ġ4) Reinstall the hood heat liner. Loosen the screw under the nozzle, aim, and re-tighten the plastic screw. Repeat as required until you get it aimed like you want. The Granite series consists of front and rear bumpers, inner and outer front and rear fenders, and rock rails stylized to match your JL Wrangler or Gladiator.
#Remove wrangler jl bumpr trial#
*Note* Trial and error will help you aim. My 84 D150 has the painted gray rear step bumperI have axle flipped the rear and the step bumper just isnt jiving anymore. And theres no need for a separate hitch installation as its already built into the bumper. I aimed mine directly towards the wiper blades to help them gather more fluid when wiping across the window. Immortal R3 Rear Bumper (2018-20 Jeep Wrangler JL) Remove This Item. It's up to you where you want the two new nozzles to spray on the windshield. You'll likely have to adjust it after the test-spray step.ġ3) Time to test the spray pattern. As you do this, roughly gauge the aiming point to where you want it to spray on the windshield. Carefully screw the retaining screw onto the bottom of the nozzle. Lay the protective rubber on the underside of the nozzle and insert the bottom of the nozzle into the hood.
#Remove wrangler jl bumpr install#
*Note* The bumpers have to be slightly "pinched" from the sides right up against the hood as there are retaining wings (for lack of a better word) which hold it in place.ĥ) Install the new washer nozzles. Looking for an aftermarket Jeep Wrangler (JL) Bumper D-Ring replacement Our low price guarantee and fast shipping will save you time and money. They push through from the underside of the hood.
If you're worried about damaging it simply pick it up and set it aside.Ĥ) Remove the hood bumpers. *Note* I left the hood liner laying over the engine while working so it could act as a pseudo work bench. Grab the hood prop and re-prop the hood back up. Hold the hood up with one hand, lower the hood prop, and with your free hand, slide the hood liner upward (towards the front of the hood). These need to be pulled out to release the liner.ģ) After pulling the heat liner clips, un-prop the hood.
With the parts in hand and the vacuum adapters painted black, it was time to get going on the actual install.Ģ) There are 5 round plastic push-clips that hold the hood heat-liner in place.
0 kommentar(er)
